Skip to main content

 I urgently need individuals who are willing to cooperate on my website and projects.

Vacuum tube works on 3.3V totally

Published: 14 January 2020
Last updated: 02 June 2023

Vacuum tubes are awkward, need always 6.3V filament and high supply voltage? No, they can also work on 3.3V. I have built a vacuum tube pre-amplifier that runs entirely on 3.3V, inclusive the filament voltage. Apparently, the electron emission of the filament still works at 3.3V. Despite the very low supply voltage, the tube amplifier still works well.

Intro

To be able to do experiments with vacuum tubes, I bought a cheap DIY 6J1 tube amplifier on AliExpress. Like most vacuum tube circuits, it uses a relatively high supply voltage of 60V. However, a high voltage is not always required for vacuum tubes, sometimes 12V is used. I was curious how far one can go with reducing the power supply. Nowadays the most used power supply voltage for electronics is 3.3V, before this was 5V.

6J2 vacuum tube preamp with 3.3V filament and plate voltage6J2 vacuum tube preamp with 3.3V filament and plate voltage

Circuit 6J2 tube preamp with 3.3V filament and anode voltageCircuit 6J2 tube preamp with 3.3V filament and anode voltage

Cheap 6J1 tube preamp board from AliExpressCheap 6J1 tube preamp board from AliExpress

6J2 tube preamp circuit supplied with 60V6J2 tube preamp circuit supplied with 60V

Tube preamp that runs entirely from 3.3V

Tube amplifiers are used for nostalgia reasons and to get the characteristic tube sound. For this purpose, this preamp is useful, and you can simply power it from USB. The gain is -3.5 and music sounds undistorted. Just the red light from the filament is dimmed.
With a supply voltage of 5V, resistor R1 better can be 3.9k Ohm.

Who can add more information to this page and create extra charts?

Tube preamp with 3.3V filament and supply voltageTube preamp with 3.3V filament and supply voltage

3.3V tube preamp triangle waveforms3.3V tube preamp triangle waveforms

Note that the distortion is small.

5V tube preamp triangle waveforms5V tube preamp triangle waveforms

There are some oddities caused by the low supply voltage of 3.3V

  • The grid-cathode voltage is positive instead of negative
  • The grid current is very high, 0.3 mA

Vacuum tube 6J2 characteristics at very low HV voltages

Tube 6J2 characteristics with 3.3V filament and anode voltage: Ia vs UgkTube 6J2 characteristics with 3.3V filament and anode voltage: Ia vs Ugk

Note that the control-grid voltage is positive.

Tube 6J2 characteristics with 5V filament and anode voltage: : Ig vs UgkTube 6J2 characteristics with 5V filament and anode voltage: : Ig vs Ugk

Note that the control-grid current Ig is very high!

See also this project at Hackaday

Links

http://www.valvewizard.co.uk/pentode.html

Other articles from Tech tips electronics